DECOBEACONS

DECO BEACONS Adds decorative beacons DECO BEACON Beam collides with block GHOST DECO BEACON Beam passes thru blocks Block has no collision itself OMNI BEACON Beam can be redirected also has ghost variant FAKE BEACON Looks like an actual beacon... Also has ghost variant HOW TO TURN ON/OFF give it a redstone signal to activate the beacon. Toggle ActiveLow mode by R-Clicking it with a redstone torch SET COLOR Cycle thru the colors by R-Clicking the beacon with an empty hand. Shift R-Clicking it cycles thru the colors in reverse. R-Clicking it with a dye changes the color. It does not consume the dye. SET BEACON TRANSPARENCY DecoBeacon light beams can pass thru other decobeacons and change the beams color. R-clicking with a Sand block makes the surface abrasive and stops the light beam from passing thru. Applying sand to a ghost beacon doesn't stop any light beam from passing thru however it does stop the ghost beacon from affecting the light beam's color USE GHOSTS Each beacon has a ghost variant. They work the same way with a few exceptions. Light beams from Ghost beacons pass thru blocks (except opaque beacons). As "ghosts" these blocks don't have collision letting you walk thru them. ### USE BOOK SETTINGS We can write down beacon settings in a Book-&-Quill and apply it to a beacon by R-Clicking. Make sure to separate each setting with a comma "," and recheck what we type in. The beacon will "calmly" point out what we did wrong ### General Settings: - ### activeLow:true/false * if set to true, the beacon is "ACTIVE" when the redstone signal you give it is "LOW" - ### isTransparent:true/false * if set to false, decobeacon light beams cannot pass thru this decobeacon... except if this decobeacon is a ghost variant. * setting this to false on a ghost variant beacon stops the beacon from affecting the passing light beam's color - ### color:white/orange/magenta/light_blue/yellow/lime/pink/gray/light_gray/cyan/purple/blue/brown/green/red/black * set beacon color ### OmniBeacon Exclusive Settings: The following settings only work with omni beacons - ### direction: north/south/east/west/up/down * sets the direction of the light beam - ### maxBeamLenght: integer * sets the max length of the light beam Examples: DECOBEACON SETTINGS: OMNIBEACON SETTINGS: